This time, we share the high voltage protection operation of the As series laser tube.

Why does the laser tube need high voltage protection?

For any type of laser tube, if the high-voltage end protection is not good, it is easy to happen high-voltage ignition or leakage!

This is absolutely a nightmare for the laser tube, and a slight carelessness will cause irreversible damage such as breakdown.

Therefore, high voltage protection is necessary!

Today, we will first report on how to do high-voltage protection for As series laser tubes!

Tool preparation: 

Wire stripper, insulating strip, high pressure cap, screwdriver and high voltage wire.

The first step:

Use a wire stripper to peel the high voltage wire.

The second step:

Use a screwdriver to loosen the high pressure end cap.

The third step:

Snap the tightened wire into the screw cap and tighten the screw cap with a screwdriver to ensure that the high-voltage wire tip is not inserted into the screw cap.

(Note: the line avoids bifurcation, and the line bifurcation will cause the high voltage tip to discharge)

The fourth step:

Use an insulating strip to secure the high-voltage line connection.

The fifth step:

Align the fixed high-voltage wire connection position with the raised part of the high-pressure cap.

The sixth step:

Insert the connected high-pressure end into the high-pressure cap to ensure that the air inside the high-pressure cap is completely discharged.

The seventh step:

The outer edge of the high pressure cap is closed with an insulating strip.

The eighth step:

The high voltage end protection is complete.

If you have questions ,please leave a message at the bottom of the article. We will answer the questions and adjust the knowledge in time.

Hope this can provide beneficial help to everyone.